The radio bus system we are going to talk about is designed to equip or quickly and easily upgrade building control systems – single-family and two-family homes, apartments, and is also an ideal option for smaller facilities – such as restaurants, office premises and reception areas.
The radio system is a set of components connected to each other via a radio channel. It has a high degree of flexibility and is very easy to install and configure. With the help of radio transmitting devices, it is easy to turn on and off the light, adjust its brightness and create the necessary light scenes, raise and lower the blinds; the radio thermostat will allow you to regulate the temperature in the room, and the radio guard will perform security functions, etc.
It does not matter where the devices are located — they can be located within the premises, on the roof of the house or even in the basement. The control devices of the radio bus system do not require any network infrastructure and can be installed anywhere, even where there is no 220 V electrical wiring. Another huge advantage is that it is possible to supplement the system with new devices at any time, and in case of moving it can be easily dismantled and taken with you.
No special knowledge is required to configure the radio bus system. All elements of the radio system are divided into two parts — «commanders» (radio transmitting devices) and «executors» (radio receiving devices). The principle of operation is very simple: the radio transmitting device sends a telegram, the «executors» who are programmed with this device receive and execute it.
The radio bus system allows for individual, user-friendly lighting control conditions. The radio transmitter, which has a particularly flat design, is mounted directly on the wall (no additional mounting housing is required) or glued to a smooth wooden or glass surface. The transmitter is independent of the power grid and is installed at the point in the room from which it is most convenient to control the light. The developers have also provided for another situation, when conventional switches already in the house are used to transmit radio commands. One of the elements of the Gira radio bus system is the Mini radio switch, which is designed for installation directly behind the mechanisms of pushbutton and key switches (already installed in deep mounting boxes). It converts commands from conventional switches into radio commands. Select the desired mode and turn the light on and off without unnecessary hassle.
You can also control light scenes from anywhere in the room using the Komfort handheld radio remote control, which implements 24 commands and is equipped with a memory function and can “remember” up to 5 scenes. The actuators of the system are also diverse. This can be a radio adapter for a socket with a switch function and a universal dimmer with radio control, etc.
I would like to say a special word about the radio switch, which is easy to install, for example, behind a false ceiling. Various cabinets can also be used as a place for its installation: receiving a command from a radio transmitter, the switch turns on the lighting of a display case or a work area in the kitchen, and obediently carries out other commands.
Meanwhile, it is worth recalling that each of the actuators can be configured for 30 control commands from radio transmitters. The range of the system is 100 m (in an open field), but this is an ideal option, which is unattainable in real life, so when designing objects using a radio system, it is necessary to take into account the attenuation of signals when passing through any obstacles. To increase the range, radio signal repeaters are used, which amplify the weakened signal and transmit it further with maximum power. The radio bus system also “thought out” situations when short-term lighting of some auxiliary rooms, stairs, areas adjacent to the house, etc. is necessary. Automatic lighting control in such places is easy to implement thanks to the use of motion sensors — they operate on batteries and can be installed anywhere. Registering movement, the sensors immediately transmit a “radiogram” to the actuator, which in turn turns on the light. After the movement stops, the light turns off. It is undeniable that along with comfort, energy savings are also achieved.
A few words about the radio guard: it can be installed in the garden or directly on the gate of the house, in a word, where you need «an eye and an eye». The «guard» will record an uninvited guest who has approached the house, having detected a change in the temperature field in the protected area. The sensor, which does not require electrical wiring, is triggered — and: the alarm is turned on; the gate closes; the light comes on, etc. The mobility of the radio guard is one of its advantages over other similar devices.
With the help of a radio thermostat, you can regulate the temperature in the room. A radio thermostat equipped with a timer, together with a radio-controlled servo drive will help organize a climate control system. The radio thermostat is programmable for 32 different time moments. During the day, according to the schedule, the thermostat measures the temperature in the room and compares it with the set value. If there is a need, the radio thermostat sends commands to one or more servo drives that control the valves. The time of day when it is necessary to turn on or off the heating is set taking into account the individual needs of the user. The right temperature — at the right time.
With the help of a radio controller, various radio receiving devices are controlled. Control can be done both for each device separately and for the entire group as a whole, manually, by temporarily turning on or programming light scenes.
The possibilities of using the Gira radio bus system in Russia are limitless. Millions of buildings can be equipped with this convenient energy-saving system without spending extra money or resorting to labor-intensive and inconvenient installation. The radio bus implements a whole range of functions, without which it is no longer possible to imagine modern comfort.
Gira's immediate response to any changes in demand and a subtle business strategy have become the foundation that has allowed it to build a «building» of competitiveness and authority for the company. The combination of advanced technical innovations, quality and high design style has enabled the company to be among the leaders in the field of electrical installation equipment production for many years. Today, the company produces several thousand product names — from ordinary sockets to complex electronic devices (dimmers, touch switches, timers, etc.) and bus system components, and all these products belong to the hi-class. Effective marketing was able to «open» Russia for Gira. The company has been present in our market for over 10 years, its products are used in elite residential buildings and prestigious administrative complexes.
Modern electrical installation is coziness, comfort and safety of your home and office. This is the path to an «intelligent building». Go through it with Gira.
Gira representative in the Russian Federation is «Giland». Tel.: (495) 232-05-90, (812) 541-84-90, (343) 365-70-57, (861) 220-15-33
Detailed information about Gira products on the website gira.ru |
Добавить комментарий